Monday, April 22, 2013

[MW:17497] RE: 17493] PWHT for CS weld in NaoH service

Mr. Kulkarrni,
 
If you look through the first attachment, 50% NAOH concentration and 82 Deg of design temperature would call for PWHT of the welds and pipe bends( following forming).This is an universal materials selection diagram which is illustrative in NACE- SP0403-2008 (formerly RP0403), Avoiding Caustic Stress Corrosion Cracking of Carbon Steel Refinery Equipment and Piping.
 
Generally maintaining  a hardness lower that 200 HBW is recommended
 
Use of rubber lining is permitted subject to the fact that all only  specific types of rubber are recommended of 50% NaOH caustic solution(see the 2nd attachment). The rubber lining has to be leak tight and there should be a good inspection technique to ensure the integrity of the lining is  good after years of service. If the lining is not good and the C.S welds are not heat treated , there's every possibility that welds may get attacked.
 
Hence I would think PWHT or No PWHT should be a judgment call of the owner/client. After all the cost for PWHT will be lot cheaper than the cost of procuring the new equipment.
 
One  argument could that operating temperature is 35 Deg C, i.e C.S (without PWHT) is still safe to use. However  ultimately the design parameters are essential to adopt or waive PWHT for the welds and bends.
 
Thanks
 
 
 

Pradip Goswami,P.Eng.IWE

Welding & Metallurgical Specialist

Ontario, Canada.

Email-pgoswami@sympatico.ca,

pgoswami@quickclic.net

 


From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of manish kulkarni
Sent: Sunday, April 21, 2013 6:26 AM
To: materials-welding@googlegroups.com
Subject: [MW:17493] PWHT for CS weld in NaoH service

Dear Experts,
 
Any idea or ref. for using CS without PWHT of piping welds with NaoH service?
The process fluid is almost 50% NaoH and design temp. of 82 Deg.C , operating temp. @35 Deg.C.
Now the issue is by using rubber lining on ID side of piping, still PWHT is required for CS welds?
Any literature available for NaoH service and CS materials?
 
Regards,
 
Manish Kulkarni
 
 

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
 
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.
 
 

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...