Monday, April 15, 2013

[MW:17391] RE: 17372] PRE HEAT PROCEDURE OF E 7016 -1 ELECTRODE

Hi,

You are fully complied with procedure already as you mentioned below, but I think you should check the welding condition like wind prevent,..or preheat before welding…

Wish you success

 

Best Regards,

Vu Duc Thuan

Phone: +84(0) 983 017 936

 

From: materials-welding@googlegroups.com [mailto:materials-welding@googlegroups.com] On Behalf Of jiji lal
Sent: Saturday, April 13, 2013 12:07 PM
To: materials-welding@googlegroups.com
Subject: [MW:17372] PRE HEAT PROCEDURE OF E 7016 -1 ELECTRODE

 

SIR,

I'm engaged with welding of API 5LX 80  grade pipeline for regassified LNG transmission . We do  Tie-in method using SMAW+FCAW.

For root pass welding we use E7016-1 electrode after pre heating 250 degree for 2 hr in mother oven and maintain 100 degree in holding oven . during RT interpretation severe hollow bead and porosity observed in root .hence PMC sent almost all joints for repair.now it becomes a serious issue and I think ,the pre heat method was not proper. kindly advice me in this issue.

 

Mr.Jijilal k .m

qa/qc dept. tecpro ltd.

kochi.

--
To post to this group, send email to materials-welding@googlegroups.com
To unsubscribe from this group, send email to materials-welding+unsubscribe@googlegroups.com
For more options, visit this group's bolg at http://materials-welding.blogspot.com/
http://www.linkedin.com/groups/MaterialsWelding-122787?home=&gid=122787&trk=anet_ug_hm
 
The views expressed/exchnaged in this group are members personel views and meant for educational purposes only, Users must take their own decisions w.r.t. applicable code/standard/contract documents.
---
You received this message because you are subscribed to the Google Groups "Materials & Welding" group.
To unsubscribe from this group and stop receiving emails from it, send an email to materials-welding+unsubscribe@googlegroups.com.
For more options, visit https://groups.google.com/groups/opt_out.
 
 

No comments:

Re: [MW:34832] Inquiry about Single Bevel with Back Grinding

Dear Uday, As per your question that one is called with backing only,Simple both side you are welding it is backing with strip or without st...